CZ TS 2 [base model] red dot mounts

CZ TS 2 [base model] red dot mounts replace the rear sight in the dovetail so you can mount an optic on a non-Optics Ready TS 2—no milling and fully reversible.

Why choose a dovetail mount?

• No permanent mods: run a red dot without altering your base TS 2 slide.
• Test before committing: try optic models/positions, then swap back to irons in minutes.
• Clean setup: model-specific fit designed to stay tight through training and matches.

Commonly supported footprints

• Trijicon RMR footprint
• Shield RMSc footprint
• Holosun K-series footprint
• Leupold DPP footprint
• C-More RTS footprint
• Vortex Venom / Docter footprint
• Aimpoint ACRO footprint

Install basics

• Degrease interfaces and screws; apply Loctite threadlocker.
• Torque to spec for mount-to-slide and optic-to-mount screws; recheck after your first range session.
• Verify screw length & pitch so nothing protrudes into the slide channel.

Running an Optics Ready TS 2?

For OR slides, a plate provides a lower, more rigid interface—see Optics Ready plates.